Manual Cutting
In manual cutting mode, operators can precisely define the position and width of the strips according to their requirements.
![[image]](/acrylcut/manueller_zuschnittmodus.png)
Positioning Options
The mode offers six different positioning options.
Left
The strips are filled starting from the left edge
Right
The strips are filled starting from the right edge
Full Strip
A cut across the entire width without longitudinal cut
Centered
The strips are aligned centrally on the fabric strip
Both Sides
Cutting alternates between left and right
Half Strategy
The fabric roll is divided in the middle
Procedure
Operation follows this sequence:
- Select the desired positioning option in the upper area
- Click on "Add Strip"
![[image]](/acrylcut/bahn_hinzufuegen.png)
- Select the required template (for example, rectangle)
- Define the height and width of the strip
![[image]](/acrylcut/bahn_dimensionen.png)
- Check the cutting preview on the right side
- Repeat the process for additional strips
INFO
The maximum possible number of strips is limited by the available cutting heads. If this number is exceeded or in case of invalid cutting configurations, a corresponding warning message appears.